Ok so for an introduction, I bought an ed hatch for $100 with no engine. I have no previous knowledge of working on cars. The same guy was selling a fully built d16y7 -crank from an ek for $600. My friend told me to buy it and here I am 6 months later. What was supposed to be a bolt in swap has...

Has anyone tried the push button “ghost key” by JDi (Jordan Distributors inc.) yet? I just bought one and I’m thinking about doing a post about one -if there’s any interest. Sorryyyy if this has been covered…I couldn’t find anything in the search about it

If you swap your motor in California you need to have in inspected by a state referee. You will need to e-mail the following before your visit (copied and pasted from referee e-mail). Vehicle Registration Donor vehicle VIN Picture of the front of the vehicle with the hood closed. Pictures of...

Hi all, I’m just looking to have someone confirm the angle of the cargo bulkhead, mine is all busted up and I’m about to fiberglass it back to life. Is the bulkhead supposed to run in a straight line or does it have a bend towards the top? if you were to view it from the side. I have a feeling...

88-91 USDM CRX differences General Specs and Info The 2nd gen CRX ran from 88-91 and came in 3 different trim levels, the Hf, Dx and SI. Trim Levels: Hf, "Dx" and SI. All came with a variant of the d series SOHC motor. Hf having the lightest curb weight, lowest hp, but best fuel economy. and...