[Tiersin]

I'm not sure if this should go in the mod or stock section, so if it needs to be moved, sorry.

for those (2) of you who have been keeping track, i've finaly brought my mini-me to life. Only problem now if the O2 heater. I am getting a code 41(O2 Heater). I have an NGK o2 sensor. On it, there are 1 white, 1 green, and 2 black wires. I have the green as the sensor, the white as the heater, and the 2 blacks i figured were grounds. I have gotten a million different "right" answers to where these wires should go. I figure i have to be right with the green one, because without i signal, i'm sure the car wouldnt be running well. Any help with the o2 wireing would be helpful. Thank you.

 

[rex2nr]

The white wire is the signal, the green wire is ground, and the 2 blacks are the heating circuit. I don't believe that it matters which way the black wires go.

 

[Dren]

^yup that sounds about right to me.

 

[Tiersin]

i have the green as signal. I'm not getting a code 1, so i figured that was right.

 

[bobski]

[The right answer]

One of the heater wires gets ignition switched power, the other goes to the ECU.