Honda CRX Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
861 Posts
Discussion Starter · #1 ·
ok i am going to be putting my d16 soon, i am just going to use my hf trans for now b/c i want this badboy in lol

now my ? is this is a direct bolt in right? i have the ecu from neil and the harness already attached,

do the motor mounts attach the same or do i need si mounts

my ac compressor should bolt right up too right?

thanks in advance, this is my first motor swap and i know these are stupid ?s but i just want to make sure
 

· Registered
Joined
·
9,754 Posts
Drops right in. You had an HF so you should already be all set for MPFI. Set aside a little time, and if you have another person or two it will be a LOT easier, someone to move the motor around and someone to work the hoist. Watch your fingers, and also watch out for the radiator if you didn't take it out (you should, makes it easier).
 

· Premium Member
Joined
·
4,516 Posts
^^^What Tom said + be careful that you dont hit the TPS(Throttle position sensor/located on the TB duh) on the firewall.They are delicate and tend to get broken easily.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top