Honda CRX Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
9,746 Posts
Try using a slightly smaller socket and hammering it on, maybe heat it up first so it expands a little, and then force it over the rounded plug and let it cool so it locks on. They really shouldn't be in there that tight so it shouldn't need that much force. Make sure to use a socket you don't care about using again. Better yet, go get a cheap one, because the metal won't be great quality and it will more readily form around the plug. I did something similar to this to rebuild the forks on my motorcycle.
 

·
Registered
Joined
·
9,746 Posts
That sucks man. I'm out of ideas... maybe try getting some high temp paint and put an "H" on the valve cover, and put a little of this in the motor:


Maybe if you fool it into thinking it's a Honda, it will come out?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top