Honda CRX Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,472 Posts
Full metal said:
ok so I am trying to find a new intake system for my B16 I plan tore-do the whole thing from the filter, piping, throttle body, manifold and a port job. I am planning on a skunk2 70mm throttle body probably an AEM intake and K&N filter but I dont know what I am doing for the manifold any body have ideas??
I think the SKUNK2 intake is simple and works great. The BLOX intake is EXACTLY the same and much less money. I would go for that. I have seen both side by side and I cannot tell the differnece.

I got my throttle body bored out instead of getting the SKUNK2. It looks very cool.
If your interested I could dig up who did it for me. Was a lot less than the 70mm SKUNK2.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top