Honda CRX Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
912 Posts
Discussion Starter · #1 ·
How exactly should I be doing this. At first, I was using the top of the piston, but upon further inspection, there are a few places I should be measuring. Can anybody clarify exactly how I should be measuring the different aspects of the pistons and cylinders to make sure there within tolerances?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top