[PHATpinoy]

Ok i know there are thousands of threads about doing the mini-me z6 on the d16a6 but I coudnt find the complete list of what I would need and how much it would cost. So if you Friendly people can link me to it or answer my question it will be appreciated

 

[jmart]

http://crxcommunity.com/viewtopic.php?t=2558&highlight=swap

http://crx.honda-perf.org/articles/z6swap/z6swap.html

http://crx.honda-perf.org/articles/moreminime/moreminime.html

Cost, depending on how you do it and where you get the parts I'd say anywhere from $500-$1000

 

[PHATpinoy]

Thanks jmart...time to get busy 8)

 

[PHATpinoy]

Ok, my friend is giving me his d16z6, can i just swap the whole engine with the same mounts because its the "same" block? and I know i need the ECU. Can I still use my Si tranny with that engine?

 

[jfrolang]

The Z6 should bolt right in, and you can keep your Si trans.

You can run it with the PM6 (Si) ECU as well, but that would require a VTEC controller or some other piggyback device. The best way to do it is to convert to OBD-1 and use the P28 (Z6) ECU.

 

[cashkidd720]

i have a mini-me swap and i have tha Si ecu can i get a 92-95 civic Si ecu and tha v-tec with kick in when i wire it up?

 

[ollie]

i have a mini-me swap and i have tha Si ecu can i get a 92-95 civic Si ecu and tha v-tec with kick in when i wire it up?

As jeff recommended it is much easier IMO if you convert to OBD1 w/the P28.
I run a mini-me setup and I converted.Not that hard to do.I know that RYWIRE makes conversion harnesses that make it almost plug and play.

 

[cashkidd720]

iight thanx

 

[Wasuri]

I have a obd0-1 conv harness that you would need if you want to run a p28 for sale. LMK if youre interested.