That is impressive. Seems like he works with those materials quite often.
Not a rex, but a fine ipod mount
1 - 6 of 6 Posts
Yeah, if you check his home page, he's got a similar setup for a nano and does a lot of work with movies and special effects.Neil said:That is impressive. Seems like he works with those materials quite often.
Holy scheisse that's cool. I wanna do that too!!
In fact... I -AM- going to do it!
I'm gonna look up where I can find some of those materials...and design a custom e-brake cover with cupholders!
In fact... I -AM- going to do it!
I'm gonna look up where I can find some of those materials...and design a custom e-brake cover with cupholders!
A modified center console cover might be more convenient and easier to mold. The ebrake cover has tabs on it's underside to hold down it's rear end... I'm not sure how you would mold them with the above technique. On the other hand, the center console cover is simply screwed down.SETI20 said:I'm gonna look up where I can find some of those materials...and design a custom e-brake cover with cupholders!
Do it...then make millions off us by mass production! YESSS!SETI20 said:In fact... I -AM- going to do it!
I'm gonna look up where I can find some of those materials...and design a custom e-brake cover with cupholders!
1 - 6 of 6 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Honda CRX Forum
A forum community dedicated to Honda CRX owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Recommended Communities
