Honda CRX Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
731 Posts
Chance are you will have to do that but I wouldn't do it just yet. Pull the sliders out and wire brush them followed by a good re-greasing. If you don't have any specifically formulated for the job, use petroleum jelly. If that don't free it up then the problem is a stuck/binding caliper piston. IMO that's not worth rebuilding because the cylinder walls are pitted from rust/corrosion and it just wont work the same anymore. Even if you can get it to work, the problem will reoccur again because the pits allow/hold air/moisture to get in there. -That's just what I think.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top