Honda CRX Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
1,670 Posts
bro i say giver ,my buddy did it and it turned out pretty good .he even wet sanded after the top coat and then cleared it with trimclade clear $9 bucks a gallon and then poilished the poop out of it with a simoniz 8 inch polisher 8)
 

· Registered
Joined
·
1,670 Posts
ive been useing gravity feed guns for a year or 2 and there not that hard ,really youll have more chances of running the paint with a rattler can then a gun :wink:

the only advice i can give is try it out on some card board to set your regulator ,set it lower at first until you get used to the gun

keep the gun at least 6 inches from the area your painting
do 50/50 over lapping and you never run

but an inline air filter so you dont shot water out the gun while your painting

mixing, rustolem paint is really thick stuff so reduce reduce reduce lol

and have fun :D
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top