Honda CRX Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
88 Posts
Discussion Starter · #1 ·
I had a B18a1 swapped into my CRX. I now notice that there is a plug and a connector that I have no idea where they go. The green connector is on the back of the block. The off white plug is coming form the same wiring of the alternator wires. I have pictures but i don't know how to post them.
Thanks
 

· Registered
Joined
·
293 Posts
code 9 is a cylinder position sensor.. ive been out of the game for a while but im pretty sure thats in the distributor...

there was a sensor on the back of the si intake manifold that as far as i concerned did nothing. if you unplugs it it didnt run any differently or threw a code. that should be your clear colored connector... the ls motor doesnt have that sensor i do believe.

as far as the green one take a picture load it onto a host site and post the link..

scarponze
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top