Honda CRX Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
778 Posts
Discussion Starter · #1 ·
I believe I have it wired up correctly. Since my ECU doesn't have a VTEC signal sent to the solenoid I just took the pink wire (the VTEC output from the VAFC) and ran it to my solenoid. There is a readout that should go from NO to YES when VTEC kicks in on the unit and that does not happen. I tested my solenoid with a lead straight from the + on the battery and I hear it clicking.

Did I miss something? The car feels good down low but when it gets up past 5 or so the power starts to fall off, that's when my A6 used to pull hard.

Yes, yes I know I should just chip a p28 or go hondata but this is all I have at the moment.

thanks,

nick
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top